RAD-Series RADIUS Server Product Support
RAD-Series RADIUS Server Frequently Asked Questions
Frequently Asked Questions (FAQ's) are arranged by topic.
If you do not find the answer to your question(s) here,
please go to the Contact
Support page and complete the form.
RADIUS Server General FAQ:
|
1. What are the system requirements for
the RAD-Series RADIUS Server? |
|
2. With which NAS vendors do the
RAD-Series RADIUS Servers interoperate? |
| |
|
| |
1. What are the system requirements for the
RAD-Series RADIUS Server?
To install and use the software, the system should meet the
following recommended specification::
-
One of the listed versions (or higher) of a supported
operating system:
-
Red Hat Distributed Linux 7.2, 7.3, and 8.0.
Also Red Hat Entperprise Linux ES Release 3 and 4 on
Intel hardware
-
Sun Solaris 8, 9, and 10
-
Disk space:
-
60 MB are required for basic installation. During
operation the server generates both system and session
logfiles. The disk requirements for logging depend upon
the transaction rate and the frequency with which the
logs are backed up and purged from the system.
-
CPU speed:
-
The server is regularly tested on systems as slow as
166 MHz. The speed needed depends on the transaction
rate and the authentication type.
-
Memory:
-
The memory required is dependent upon both the
transaction rate and the number of active sessions
being managed. The server is regularly tested on
systems with as little as 64 MB of memory although
Interlink Networks recommends at least 128 MB.
|
| |
|
2. With which NAS vendors does the
RAD-Series RADIUS Server interoperate?
The RAD-Series RADIUS Server should work with any RADIUS
RFC compliant NAS. RAD-Series RADIUS Servers are being
used successfully in configurations with NAS's from a
braod range of vendors including the following:
-
Ascend/Lucent
-
Avail
-
Bay Networks
-
Cisco
-
Computone
-
Compaq/DEC
-
Livingston/Lucent
-
Shiva/Intel
-
Telebit
-
Unisphere
-
US Robotics/3COM
|
|
| |
If you do not find the answer to your question(s) here,
please go to the Contact
Support page and complete the form.
|
